# Note: in addition to these parameters, you need to have working    -*- sh -*-
# configuration file for lircd (and lircmd if enabled).

# Options to lircd(8).  Typically, this will be empty, as which driver to use
# should be specified using the LIRC_DRIVER variable below.
LIRCD_OPTIONS=""

# The infrared receiver (and/or transmitter) driver to be used by lircd(8),
# similar to passing "-H driver" to lircd(8).
# Run "/usr/sbin/lircd -H help" to get a listing of supported drivers.
LIRC_DRIVER="default"

# Which lirc device will be used by lircd(8).
# This is the same as passing "-d device" to lircd. It must be set.
LIRC_DEVICE="/dev/lirc0"

# Options to lircmd(8). lircmd always runs with --nodaemon added
# to LIRCMD_OPTIONS.
LIRCMD_OPTIONS=""

# The infrared device used by lirc, if any. If this is set, lircd will
# enable the lirc protocol and disable kernel built-in handling using
# "echo lirc > /sys/class/rc/$LIRCD_IR_DEVICE/protocols" at startup.
# If unset, this is ignored.
# - The common case when there is just one ir device: LIRCD_IR_DEVICE="rc0".
# - Non-IR devices e. g., RF ones typically don't need this set.
# - If not set when required, the typical symptom is duobled key-presses.
# - If installing the lirc-disable-kernel-rc subpackage this setting is not
#   needed.
LIRCD_IR_DEVICE=""