From: Prasad J Pandit Date: Tue, 28 Feb 2017 12:08:14 +0000 Subject: [PATCH] sd: sdhci: check transfer mode register in multi block transfer In the SDHCI protocol, the transfer mode register value is used during multi block transfer to check if block count register is enabled and should be updated. Transfer mode register could be set such that, block count register would not be updated, thus leading to an infinite loop. Add check to avoid it. Reported-by: Wjjzhang Reported-by: Jiang Xin Signed-off-by: Prasad J Pandit Message-id: 20170214185225.7994-3-ppandit@redhat.com Reviewed-by: Alistair Francis Signed-off-by: Peter Maydell (cherry picked from commit 6e86d90352adf6cb08295255220295cf23c4286e) --- hw/sd/sdhci.c | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-) diff --git a/hw/sd/sdhci.c b/hw/sd/sdhci.c index f4cf5c7..fedc786 100644 --- a/hw/sd/sdhci.c +++ b/hw/sd/sdhci.c @@ -485,6 +485,11 @@ static void sdhci_sdma_transfer_multi_blocks(SDHCIState *s) uint32_t boundary_chk = 1 << (((s->blksize & 0xf000) >> 12) + 12); uint32_t boundary_count = boundary_chk - (s->sdmasysad % boundary_chk); + if (!(s->trnmod & SDHC_TRNS_BLK_CNT_EN) || !s->blkcnt) { + qemu_log_mask(LOG_UNIMP, "infinite transfer is not supported\n"); + return; + } + /* XXX: Some sd/mmc drivers (for example, u-boot-slp) do not account for * possible stop at page boundary if initial address is not page aligned, * allow them to work properly */ @@ -796,11 +801,6 @@ static void sdhci_data_transfer(void *opaque) if (s->trnmod & SDHC_TRNS_DMA) { switch (SDHC_DMA_TYPE(s->hostctl)) { case SDHC_CTRL_SDMA: - if ((s->trnmod & SDHC_TRNS_MULTI) && - (!(s->trnmod & SDHC_TRNS_BLK_CNT_EN) || s->blkcnt == 0)) { - break; - } - if ((s->blkcnt == 1) || !(s->trnmod & SDHC_TRNS_MULTI)) { sdhci_sdma_transfer_single_block(s); } else {